American MGB Association Message Board

General Area => General Discussion => Topic started by: amgba on September 13, 2015, 10:52:05 PM

AMGBA website home page or AMGBA Photo Gallery or AMGBA Club Blog
Subscribe in a reader

Join or renew today and receive a free t-shirt or tech CD, see details in the join the club section at!

Title: Starter Not Engaging
Post by: amgba on September 13, 2015, 10:52:05 PM
The starter on my 1967 MGB does not engage every time I turn the key.  More and more often it makes a spinning noise then it will eventually catch and turn the engine over.  When it finally catches it is not really a powerful crank but will crank enough to start.  Any thoughts on what the problem might be? Thanks.

Bruce Payne
Amarillo, Texas
Title: Re: Starter Not Engaging
Post by: Art on September 13, 2015, 11:01:15 PM
I would actually start with the battery and connections.  What you describe sounds like a weak battery or corroded connection or cable sapping power to the starter. The '67 had twin 6 volt batteries hooked in series to create 12 volts .  The number of cables and connections with those as well as the limited availability of the right 6 volt replacements created issues.  Add to this that most LBCs tend to “leak” power even standing idle, the batteries drain and damage unless disconnected. 

Most of us added disconnect switches to protect the batteries (as well as the cables from corrosion ) while the cars stood idle or in storage ad well as switched to single 12 volt batteries.  And while the technology has improved over the years, those are still more compact and, because of the smaller cell size, they do wear out, even with limited use.

After checking the battery and cables, I would look at the mechanical side of the ignition switch and it’s connections to the starter before moving on to rebuilding or replacing the whole starter.

I hope that helps you.  Good luck and keep me posted on what you find.

Safety Fast!
Art Isaacs

   AMGBA website home page or AMGBA Photo Gallery or AMGBA Club Blog