American MGB Association Message Board

Technical Area => Transmission Related Discussion => Topic started by: august2007 on July 25, 2007, 02:31:33 PM

AMGBA website home page or AMGBA Photo Gallery or AMGBA Club Blog
Subscribe in a reader


Join or renew today and receive a free t-shirt or tech CD, see details in the join the club section at www.mgclub.org!

Title: Clutch Adjustment
Post by: august2007 on July 25, 2007, 02:31:33 PM
The clutch pedal on my 1979 must be depress all the way to the floor in order to shift smoothly.
The entire clutch was replaced i.e. pressure plate, throwout bearing, slave and master and hoses about 1000 miles ago by an MG shop. Is there an adjustment at the clutch master cylinder or is the clutch non- adjustable? ??? ???
Thanks,
TOM 
Title: Re: Clutch Adjustment
Post by: Art on March 19, 2008, 11:18:54 PM
Hi Tom,

 Sorry, the clutch is not adjustable.  I would check all the fluid levels and connections for any leaks or air getting into the hydraulic system.  Try bleeding the system again to see if there's any improvement.

Also, if the master and/or slave cylinders were rebuilt as opposed to replaced, even if done professionally (there's a reason none of the catalogs offer rebuilt clutch hydraulics anymore), I would take a good look at their operation and possibly consider an upgrade to new.  You might want to contact the shop you had the work done at to help.

Hope that helps you.  Good  luck.

Art

   AMGBA website home page or AMGBA Photo Gallery or AMGBA Club Blog